January 4, 2017

How to Make Oil Injections

Many clients who brought our steroid raw powders may ask “How to make Oil Injections for my own use ?”

Today we ‘d like to introduce the process of making steroid oils for our clients.All need 5 steps for making steroid injection oils.


Step 1.Assemble Your Materials



  • Carrier Oil
  • syringe (Any size)
  • Benzyl Benzoate (BB)
  • Benzyl Alcohol (BA)
  • Sterile Glass Vial (Any size)
  • Needles
  • Thermometer
  • Steroid Powder
  • Sterile Syringe filter .22um
  • Digital scales measuring to 01g


It is important to have everything you will need at hand, the best way to cook is to do everything quickly.This prevents fluctuations in temperature and excessive oxidation of your compounds – both allow the compound to reach its strengt potential and many ‘cooks’ do not allow for this. Set up your water bath by boiling the kettle and adding a 2-3cm of the boiling water into the base of a pan, or similar container –work quickly from this point so the water temperature does not drop by too much. 150f is ideal for the temperature of this water but it is not greatly important.


Step 2. Select the recipe


Depending on what you are planning to make select the appropriate recipe and adjust if required. Weigh the appropriate amount of Steroid powder into the glass beaker and then add the correct amount of Benzyl Alcohol according to the recipe you are using. In this example the following recipe is used:-


  • 50ml Tren Acetate 5g Tren Acetate powder
  • 1ml BA
  • 10ml BB
  • 35ml Grape-seed oil




Step 3.Dissolving & Warming.


Add the Benzyl Benzoate according to the recipe you are using and place the glass beaker in the water bath, sitring vigorously until the powder is fully dissolved (no grains at the bottom).


Step 4. Add The Carrier Oil.


Once fully dissolved add the warmed carrier oil (Grape-Seed oil reccomended) and stir while heating until all the ‘Hormone Swirls’ are gone, then remove from the heat.




Step 5. Filtering.


Draw up the mixture into the syringe you will be filtering with, remove the 0.22um Sterile Syringe filter from its packaging and fix the green needle to the smaller side and then apply to the syringe. Wipe the top of the sterile vial with an alcohol swab and put a green needle in it, and then put the needle attached to the syringe filter into the vial:



Pls watch the followng video to see how sterile syringe filter work.



You have now successfully completed the process of producing Hormones. It is a very straight forward process and requires no expertise. In this example Trenbolone Acetate.



Steroid Knowledges , ,
About lynn518

Leave a Reply

Your email address will not be published. Required fields are marked *